by Abrisa Technologies | Aug 6, 2021 | Fabrication Facts
Glass that has been tempered or heat strengthened cannot be machined. Any fabrication done prior to the heat or tempering process must be smooth as well as chip and crack free. Any holes, notches, etc. should be located on the fabricated glass part so as to avoid...
by Abrisa Technologies | Aug 6, 2021 | Fabrication Facts
Low Iron Soda-Lime Glass or water-white glass is a clear transparent soda-lime-based glass that is almost tint-free, resulting from its being produced from higher quality grades of silica sand that are almost totally free of iron oxides. 1/8” thick low iron glass...
by Abrisa Technologies | Aug 6, 2021 | Fabrication Facts
Flat glass that has a seamed edge or slightly beveled edge is that which has been lightly sanded to remove any sharp burrs for. This glass is safe to handle but is not intended for decorative use. A sanding belt is used to lightly sand off the sharp edges of the glass...
by Abrisa Technologies | Aug 6, 2021 | Fabrication Facts
Strengthening glass can be done via three primary processes; tempering, thermal strengthening and chemical strengthening in order to increase the heat resistance and overall strength of the glass. Heat Tempering Toughened or tempered glass is a type of safety glass...
by Abrisa Technologies | Aug 6, 2021 | Fabrication Facts
At Abrisa Technologies, we offer a range of glass edge treatments that enhance both the aesthetics and functionality of glass products. Proper glass edging is essential not only for visual appeal but also for ensuring the safety, durability, and performance of the...
